Table of Contents
Advertisement
Parameter
(Output Pan)
(Output Gain)
(Output Pan Mode)
Pan Table
Crossfade Control
Crossfade Sense
Drum Remap
Exclusive Zone Map
Pan
Use this parameter to position the current layer's pre-FX signal. Negative values pan the
signal to the left channel, positive values pan to the right, and a value of zero pans to the
center. To adjust the post-FX, final-stage gain and panning of the current program, go to the
COMMON page and adjust the Output parameters (see
7-16); or to adjust a layer's post-FX audio signal individually, go to the LYR_FX page and
set the Layer FX Mode parameter to Layer-Specific FX (see
page
7-15), and then return to the OUTPUT page and adjust the output parameters.
An additional pan parameter (Pan2) appears if you have the Stereo parameter on the
KEYMAP page set to a value of On.
Pan Mode
When the mode is Fixed the pan position remains as defined with the Pan parameter,
ignoring MIDI pan messages. When the mode is +MIDI, MIDI pan messages (MIDI 10)
will shift the sound to the left or right of the Pan parameter setting. Message values below
64 shift it left, while those above 64 shift it right. A setting of Auto assigns the pan setting of
each note based on its MIDI note number. In this case, Middle C (MIDI note number 60)
is equivalent to the Pan parameter's setting. Lower notes shift increasingly left, while higher
notes shift increasingly right. A setting of Reverse shifts low notes right, and high notes left.
MIDI pan messages will also affect the pan position when values of Auto and Reverse are
selected.
Range of Values
± 64
-96 to 48 decibels
Fixed, +MIDI
Pan Table List
Control Source List
Normal, Reversed
Off, Kurz1, Kurz2
Zone Map List
Program Edit Mode
The OUTPUT Page
Default
0
0
+MIDI
0 None
Off
Norm
Off
0 None
The COMMON Page on page
The Layer FX (LYR_FX) Page on
7-41
Advertisement
Table of Contents
