Table of Contents
Advertisement
Alpha Wheel & Previous (–) and Next (+) Value Buttons
Use the Alpha Wheel or the Value buttons, to the right of the display below the Alpha
Wheel, to change the selected parameter value. Turning the Alpha Wheel counter-clockwise
or pressing the Previous button will select the previous value and turning the Alpha Wheel
clockwise or pressing the Next button will select the next value.
Assign
Assign is the secondary function of the Enter button. You can use the Assign function to
quickly select parameters or set values for parameters by holding the Enter button while
moving Forte SE controllers (Sliders, Switch buttons, Keys, Mod Wheel, and Pedals).
Parameters that can use the Assign function are indicated by showing the Assign symbol in
the top right corner of the display when selected.
Pressing a key, switch, or moving a controller while holding down the Enter button will
perform Assign in the following cases.
Enter + Controller
On the Multi CCs or Multi Switches page, when the Controller or Switch parameter is
selected, holding the Enter button and moving a controller (a Slider, Switch button, Mod
Wheel or Pedal) will jump to selecting that controller in the current Zone. This allows you to
quickly select a controller.
On the Multi CCs or Multi Switches page, when the Dest parameter is selected, Enter
+ Switch/Controller will assign the default Destination of the touched controller to the
selected switch or controller. This is an easy way assign a Multi controller/switch to the same
assignment it had in Program mode.
Selecting Parameters
Assign Symbol
Multi Edit Mode
11-3
Advertisement
Table of Contents
