Panasonic KX-TDA200 Features Manual page 303

Conditions
•
SMDR Format
The following SMDR format can be set through system programming in order to match the paper size being
used in the printer:
a.
Page Length: determines the number of lines per page.
® 13.1 [11-1] Main—SMDR—
® [802] SMDR Page Length
b.
Skip Perforation: determines the number of lines to be skipped at the end of every page.
® 13.1 [11-1] Main—SMDR—
® [803] SMDR Skip Perforation
The page length should be at least four lines longer than the skip perforation length.
Explanation:
Skip
Perforation
•
SMDR data is not deleted even if the PBX is reset.
•
If the PBX is reset during a conversation, the call will not be recorded on SMDR.
•
The following calls are regarded as two separate calls for SMDR:
–
Calls before and after the flash/recall/EFA signal is manually sent during a conversation
–
Trunk-to-trunk calls by Call Transfer, FWD or DISA (recording each as "incoming call" and "outgoing
call")
•
The PBX waits for a preprogrammed time period between the end of dialling and start of the SMDR timer
for outgoing trunk calls. When the PBX has sent out all dialled digits to the telephone company and this
timer expires, the PBX starts counting the call. A display PT shows the elapsed time of the call. The starting
time and the total duration of the call are recorded on SMDR.
® 4.4 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone—
® [208] Call Duration Count Starting Time for LCOT
If the reverse signal detection has been set (® 1.5.4.5 Reverse Circuit), the PBX will start counting the
call after detecting the reverse signal from the telephone company regardless of the above timer.
•
Serial Interface (RS-232C) Parameters
The following communication parameters can be assigned for the Serial Interface (RS-232C) port.
a.
New Line Code: Select the code for the PC or printer. If the PC or printer automatically feeds lines
with carriage return, select "CR". If not, select "CR+LF".
® 13.1 [11-1] Main—RS-232C—
® [800] RS-232C Parameter—New Line Code
b.
Baud Rate: A baud rate code indicates the data transmission speed from the PBX to the PC or printer.
® 13.1 [11-1] Main—RS-232C—
® [800] RS-232C Parameter—Baud Rate
c.
Word Length: A word length code indicates how many bits compose a character.
® 13.1 [11-1] Main—RS-232C—
® [800] RS-232C Parameter—Word Length
SMDR Format—Page Length (Number of Lines)
SMDR Format—Blank Footer Length (Number of Lines)
Page
Length
Machine
Perforation
Communication—NL Code
Communication—Baud Rate
Communication—Word Length
1.26.1 Station Message Detail Recording (SMDR)
Dial—Analogue CO Call Duration Start
Feature Guide 303