Oki MC860n MFP User Manual page 46

FEATURE OPTION
Print Setup Print Menu
(cont.) (cont.)
Print Setup Width:
(cont.)
2.5~8.5~11.7 inches
Length:
4.1~11~48 inches
Printer Adjust Manual Timeout:
Disable, 30 seconds,
60 seconds
Wait Timeout:
Disable, 5, 10, 20,
30, 40 seconds, 50,
60, 90, 120, 150,
180, 210, 240, 270,
300 seconds
Low Toner:
Stop, Continue
Jam Recovery:
Disable, Enable
Paper Black Setting:
-2, -1, 0, +1, +2
Paper Color Setting:
-2, -1, 0, +1, +2
Trnspr Black Setting:
-2, -1, 0, +1, +2
Trnspr Color Setting:
-2, -1, 0, +1, +2
SMR Setting:
-3, -2, -1, 0, +1, +2,
+3
Configuring Your Machine > 46
DESCRIPTION
Selects the width of the paper
defined by the "Custom" settings.
Selects the length of the paper
defined by the "Custom" settings.
Note that media of up to 1200 mm
in length can be fed from the multi
purpose tray for banner printing.
Specifies how many seconds the
machine will wait for paper to be
fed before cancelling the job.
Specifies how many seconds the
machine will wait when received
data pauses before forcing a page
eject. In PostScript Emulation
mode the job will be cancelled if
timeout occurs.
Specifies whether the machine
should continue printing even after
a low toner condition is detected.
Specifies whether the machine
should perform jam recovery after
a paper jam occurred. If enabled,
the printer will attempt to re-print
any pages lost due to a paper jam
once the jam has been cleared.
Used for micro adjustment when
very visible faded print results or
light specks (or streaks) result
when printing in Plain Paper/Black
setting.
Decrease the value if light specks
(or streaks) or snow flake like
printing results in high density
print areas.
Used for micro adjustment when
very visible faded print results or
light specks (or streaks) result
when printing in Plain Paper/Color
setting.
Decrease the value if light specks
(or streaks) or snow flake like
printing results in high density
print areas.
As for Paper Black Setting above.
As for Paper Color Setting above.
To correct variations in print
results caused by temperature/
humidity conditions and difference
in print density/frequency.
Change the setting when print
quality is uneven.