Table of Contents
Advertisement
Job Programs
If you have a routine copy, fax or scan job that you perform on a regular basis, you can
program the steps into your MFP and create a "short cut" allowing you to perform the steps
at the touch of a button. You can create six short cuts using the Job Program function.
Creating a Job Program
To register a short cut:
1.
Press the Job Program button on the control panel to prompt the Job Programs
screen.
2.
Select a job number you wish to associate to your program.
3.
Select Yes to continue, or No to exit without saving.
4.
Key in the steps you wish to program; for example if you wish to program a copy job
that is double-sided, A4(SEF) scan size and the output is 20 copies:
(a)
Press the Copy button on the control panel.
(b)
Press the Others button on-screen.
(c)
Press the DuplexCopy button on-screen.
(d)
Press the 1->2 sides button on-screen.
(e)
Press the Enter button on-screen.
(f)
Press the Scan Size button on-screen.
(g)
Press the A4(SEF) button on-screen.
(h)
Press the Enter button on-screen.
(i)
Press the Close button on-screen.
(j)
Using the numerical keypad, type in 20.
NOTE
Maximum of 60 steps per program; selecting or pressing a button counts as
one step.
It is a good idea to write down the steps to be performed beforehand as every
keystroke/button press is programmed.
5.
Press the Job Programs button on the control panel.
6.
Using the on-screen keypad type in an appropriate title for the program.
7.
Press the Enter button on-screen to complete the registration.
NOTE
You cannot edit the steps within a program, if you wish to change them then
you must reprogram the job number.
Operation > 110
Advertisement
Table of Contents
