Installation Instructions - German pool DWL-509A Operating Instructions Manual

安裝說明 INSTALLATION INSTRUCTIONS
3. 風管安裝辦法：先將出風口安裝
在機器上，同時墊上膠墊，用8顆
416 螺釘固定，機器掛上牆面後
再安裝出風管，出風伸縮管由鋁膜
製造，不可強拉，兩人各握一頭緩
緩拉開。同時按住螺旋線接縫，以
防脫開。然後用專用克圈固定在出
風口外圈上。
4. 根據不同的安裝環境，本機可直接
將出風管接出室外，也可接入中央
煙道。我們專門為您配備不同大小
出風口的轉換接頭，可根據實際需
要選用。出風管兩端接頭應盡可能
密封以免漏煙，出風管應盡量減少
彎折，使排煙暢通，在特殊排煙位
置上可多管連接。
5. 主機安裝完畢，最後接上電源插座。
3. Exhaust Pipe installation method:
install the Air Outlet onto the hood and
place the rubber padding at the same
time, then use 8 screws of x1 to
secure. After hanging the hood onto the
wall, install the pipe. The expendable pipe
is made of foil and cannot be pulled with
force. Two persons each gets hold of one
end and pull gently; and press the joint at
the same time to avoid detachment. Then,
use the special loops to secure them onto
the exterior ring of the Air Outlet.
. According to different interior settings, either
install Exhaust Pipes to discharge to the
outside, or connect it to central fume pipes.
There are different adapting joints supplied
for you to meet different needs. Two ends of
the Exhaust Pipes should be sealed up
to avoid smoke from leaking. Whenever
possible, avoid bends in the installation of
the Exhaust Pipe to allow free ventilation.
More pipe connections can be applied to
specific smoke discharging areas.
5. Connect power plug to socket after finishing
the hood installation.
P. 12