Table of Contents
Advertisement
Appendix A
SP2 Specifications
Audio Specifications
Line-Level Left and Right Analog Audio Outputs
Connectors
Impedance
Maximum output level
Frequency Response
Idle channel noise
Dynamic Range
Stereo Channel
Separation
Headphone Output
Output impedance
Maximum output level
Parameter Reference
Parameter
Group
Key Range
Transposition
Velocity
Continuous
controllers
These controllers
all have the same
three Parameters,
called the Basic
Parameter Group.
Usually the same,
of Ctrl Num; its
value
varies
for
each controller
A-2
Balanced outputs using two 1/4-inch stereo ( tip-ring-sleeve ) phone plugs
and shielded twisted pair cable or unbalanced using two 1/4-inch mono (tip-
ring) phone plugs and coaxial cable.
400 ohm, Balanced, nominal
200 ohm, Unbalanced, nominal
20.8 dBu (8.5 Volts RMS) Balanced, high-impedance load
14.7 dBu (4.2 Volts RMS) Unbalanced, high-impedance load
20Hz–20kHz +/– 0.6 dB
Less than -115 dBA, balanced, relative to full-scale signa
Greater than 112 dBA, balanced, using -60 dBFS signal
96 dB
47 Ohm, nominal
-4 dBu ( 0.5 Volts RMS ) with 32 Ohm load
Subgroup
Parameter
(if any)
Lo
Hi
Note Map
Transpose
Vel Min
Vel Max
Wheel 1
Up/Down
Wheel 2
Knob A
Knob B
Exit Value
Knob C
Knob D
Pedal 1
Range of Values
C-1–G 9
C-1–G 9
Linear
-24 to 24
1–127
1–127
2 Semitone
None, 0–127 (default None)
l
Default
G#3(Ab3)
G 9
Linear
0
1
127
Wheel 1 Up/Down
Ctrl Num : Pitch Up
Wheel 2 Ctrl Num:
Mod Wheel
Ctrl Num : 6
Ctrl Num : 13
Ctrl Num : 22
Ctrl Num : 23
Ctrl Num : 11
Advertisement
Table of Contents
Troubleshooting
