Table of Contents
Advertisement
Chapter 2
SP2 Getting Started
Connecting Pedals
Plug your switch or continuous pedals into the corresponding jacks on the SP2's rear panel.
Although we recommend using the Kurzweil pedals described on page 1‐2, you can use almost
any switch or continuous pedal, as long as it adheres to the following specifications..
• switch pedals 1/4 inch tip‐sleeve plugs
• continuous pedals 10k Ohm linear‐taper potentiometer 1/4 inch tip‐sleeve plug
When using non‐Kurzweil pedal, make sure it's connected before you turn on your
SP2. Also, do not press any of your pedals while powering up, or it might work backwards
because the SP2 verifies each pedal's orientation during power up.
Powering Up
When you've made all your connections, turn on the SP2. After the LEDs on the front panel
flash, the numeric display on the front panel will show a series of information. When the SP2 is
ready to play, the display will look like following:
< Figure 2‐12 Initial Display >
To prevent any damage to your sound system, set the SP2's master volume slider all the way
down before you turn on the SP2. And then, gradually push up the slider while playing the
keyboard
２-13
Advertisement
Table of Contents
Troubleshooting
