Kurzweil KME61 Musician's Manual page 49

• Changing Combination Effect
→ For this example, we're going to change the Combination Effect applied to Program 17, Pipe
16'8, reed organ.
1. Select Program 17 ( n17 ), Pipe 16'8, reed organ.
2. Press [Effect] button. The display will show "A55" and the LED in [Edit] button in the Edit
region of the SP2's front panel will blink. This means that the SP2 is now in Effect Editor
mode.
3. First, select the desired type of effect with the upper part of Sound Select buttons in the
Category region. The buttons are labeled Chorus, Flanger, Delay, Compressor, Distortion,
Filter, LazerVerb, and Misc.( Rotary Speaker, Enhancer, Simple Motion, etc.) After making
selection, select the desired preset with one of the the lower 8 buttons.
4. While holding down [Effect] button, press [Reverb] button. Make sure that the two LEDs in
each button light.
5. The display will show"b21"that indicates the current Combination Effect preset asso‐
ciated with the program.
6. Now, select the desired type of reverb with the upper part of Sound Select buttons in the
Category region. The buttons are labeled Room1, Room2, Chamber, Hall1, Hall2, and Hall3.
After making selection, select the desired preset with one of the the lower 8 buttons.
7. Press [Store] in the Edit region. The SP2 will ask if you want to store the changed effect
setting of the current Program. Store the change with [+/Yes] button and the procedure is
completed. Now, the SP2 will return to Program mode.
< Figure 4‐13 The Buttons Used within Combination Effect >
< Figure 4‐14 The LEDs blink together with Combination Effect >
Chapter 4
Programming SP2
４-7