Connecting To A Computer Via Usb - Kurzweil KME61 Musician's Manual

Connecting to a Computer via USB

Without a MIDI interface, the SP2 can be connected to a computer via USB. A single USB cable
can carry incoming and outgoing MIDI data between the SP2 and a computer. You don't even
need to install any additional driver.
Though the SP2 can use MIDI port and USB port at the same time, it may cause
problems with running out of polyphony. So, we recommend you to use either
MIDI port or USB port at a time.
What is USB?
USB is the abbreviation for Universal Serial Bus, which is a serial bus standard to interface
devices. The SP2 support "Plug and Play" feature of Windows XP.
How to Install Device Driver?
What you need
1) Any PC, Windows XP installed. ( recommend Service Pack 2 )
2) Working SP2 unit with OS V1.0( or later ) installed.
3) Type A, USB cable.
4) Go to our download page below, get "sp2series.inf".
http://www.kurzweilmusicsystems.com/downloads.html
How to install
1) Make sure where sp2series.inf file located.
2) Power up SP2.
3) After power up, connect USB cable between PC and SP2.
4) Shortly after, you might hear "ding" sound, and in the system tray
Found new hardware popup open.
5) After a while, you can see popup about new audio device.
Chapter 2
SP2 Getting Started
２-7