Kurzweil KME61 Musician's Manual page 48

Chapter 4
Programming SP2
• Changing Reverbs
→ For this example, we're going to change the Reverb applied to Program 49, Acoustic Guitar.
1. Select Program 49 ( n49 ) Acoustic Guitar
2. Press [Reverb] button. The display will show "b08" and the LED in [Edit] button in the Edit
region of the SP2's front panel will blink. This means that the SP2 is now in Reverb Editor
mode. The capital "b" means that the SP2 is now in Reverb Editor mode and the following
two digits indicate the type and the variation number of the reverb associated with the
currently selected program.
3. Select the desired type of reverb with the upper part of Sound Select buttons in the
Category region. The buttons are labeled Room1, Room2, Chamber, Hall1, Hall2, and Hall3.
After making selection, select the desired preset with one of the the lower 8 buttons. For
more information about the reverbs, refer to Appendix B ‐ 7, Effects and Reverbs.
4. Press [Store] in the Edit region. The SP2 will ask if you want to store the changed effect
setting of the current Program. Store the change with [+/Yes] button and the procedure is
completed. Now, the SP2 will return to Program mode.
４-6
< Figure 4‐10 Storing Effect Setting >
< Figure 4‐11 Reverb button >
< Figure 4‐12 The display in Reverb Editor mode >