Table of Contents
Advertisement
Chapter 4
Programming SP2
Assigning Knobs
You can program Knobs A‐D to send any MIDI control change number. The procedure is like
following:
Press [Setup] button and [Edit] button. While holding down [Knob Mode] button, turn one of
the knobs you want to program.
The display will show which knob will be programmed for a short while and then the MIDI
control number currently assigned to it. See < Figure 4‐24 >. The Knob to be programmed is A
and the assigned MIDI control number is 6.
４-12
< Figure 4-22 Turning On and OFF switch pedal >
< Figure 4-23 Selecting a Knob to be programmed >
Advertisement
Table of Contents
Troubleshooting
