→ For this example, we're going to change the Effect associated with Program 1 Stereo Grand
Piano.
1. Select Program 1 ( n01 ) Stereo Grand Piano.
2. Press [Effect] button. The display will show "E06" and the LED in [Edit] button in the Edit
region of the SP2's front panel will blink. The capital "E" means that the SP2 is now in Effect
Editor mode and the following two digits indicate the type and the variation number of the
effect associated with the currently selected program. For more information about the
effects and reverbs, refer to Appendix B‐7, Effects and Reverbs.
3. Select the desired type of effect with the upper part of Sound Select buttons in the Category
region. The buttons are labeled Chorus, Flanger, Delay, Compressor, Distortion, Filter,
LazerVerb, and Misc.( Rotary Speaker, Enhancer, Simple Motion, etc. ) After making
selection, select the desired preset with one of the the lower 8 buttons.
4. Press [Store] in the Edit region. The SP2 will ask if you want to store the changed effect
setting of the current Program. Store the change with [+/Yes] button and the procedure is
completed. Now, the SP2 will return to Program mode.
< Figure 4‐7 Buttons for Effect Setting >
< Figure 4‐8 The display in Effect Editor mode >
< Figure 4‐9 Selecting Effect Presets >
Chapter 4
Programming SP2
4-5