Table of Contents
Advertisement
7.2 Setup Functions
Initial Setting (Factory Default)
To reset functions back to initial factory setting:
1. Click OSD(Enter) to recall OSD setup menu.
2. Click UP or DOWN button to select first option on menu and click LEFT or RIGHT button to make selection. Once
selected, "Factory Initialize..." message will be displayed on screen for 4~5 seconds.
3. When "Initialize" is done, monitor screen will switch back to setup menu.
4. Click ESC button to exit menu when finished or UP or DOWN button to select next item.
Operating Mode
There are two modes to choose from, normal and tracking. Under normal mode, NVC will only surveillance the chosen
area. Under tracking mode, NVC will keep following any moving object detected in the surveillance area.
1. Click OSD(Enter) to recall OSD Setup Menu.
2. Click the Up or Down button to select "OP. Mode" on menu.
3. Click Left or Right button to make selection: Normal -> Tracking
Under OP Mode: <TRACK>, press OSD(ENTER) for more options.
1.
HOME POS: With auto-tracking on, when the moving object is out of range and the RET TIME is up, the device will
move back to preset-point (1~16). Here you could adjust the preset-point where the device will return to.
2.
RET TIME: With auto-tracking on, when the moving object is out of range and the RET TIME is up, the device will
move back to preset-point (1~16). Could adjust from 1second to 50 seconds.
3.
ZOM OPERATE: Enable the device to zoom in/out when tracking is on.
90
Advertisement
Table of Contents
