Table of Contents
Advertisement
6.
Setting Preset Dwell Time
The dwell time means the time user wants to view on certain preset position under Auto Pan the Preset Dwell
Time can be set between 0 ~ 255 seconds. (The factory default is 0 second)
* If the dwell is set to 0 second then that position will be omitted from the Auto Pan tour.
To set dwell to 5 seconds: Push key 5 followed by F2 key.
Example:
To set dwell to 5 second: 5 F2 keys
To set dwell to 10 second: 1 0 F2 keys
7.
Storing Preset Data
Once the above steps have been completed, the information must be stored or it will not be memorized by the
system.
PIH-801II:
Push key 1 followed by F3 key, two beeps will be heard confirming that data is stored.
PIH-801:
When PIH-801 is used, there is no need to perform data saving step for 1st ~ 16th preset. For 17th ~ 128th
presets F3 key should be pushed to store data.
Note: For the first 4 presets on each dome, the above steps must be repeated. For presets 5 ~ 128 there is a
default speed and dwell setting so steps 5 and 6 are not required.
Recalling Preset Positions
Once the required preset points have been stored in a dome, they may be quickly recalled returning the dome to exact
position.
To recall 1st Preset Point: Push key 1 followed by PRESET key. The dome will move to that position in speed of 360
sec.
Example:
To recall 1st preset point: 1 PRESET keys
To recall 128th preset point: 1 2 8 PRESET keys
108
o
/
Advertisement
Table of Contents
