Initial Power Up Inspection; Operating Ndc With Keyboard - PiXORD P-463 User Manual

8.2 Initial Power Up Inspection

After the power is first applied to a dome it will perform a self-test procedure. This calibrates and checks the basic
functions of the dome; control is not possible during this self-test period. Once the camera has stopped moving, it will
then be ready to control if preset points and tours have been programmed into a dome and the power is turned off, the
dome will enter the Auto Pan (auto scan) mode once the power is turned on again (after self-test period). The dome
will remain in Auto Pan until and operator cancels it.

8.3 Operating NDC with Keyboard

Manual Operation (Pan / Tilt Control)
To control the pan and tilt movement of the dome simply use the joystick on the keyboard; to pan the camera left push
the joystick to the left, to tilt down pull the joystick down (towards you). To move the dome faster push the joystick
further in that direction, the joystick is proportional to the speed of the dome; a small movement will move the dome
slower.
UP : Push the joystick forward, the camera tilt up.
DOWN : Push the joystick down (toward you), the camera tilt down.
LEFT : Push the joystick left, the camera pan left.
RIGHT : Push the joystick right , the camera pan right.
DIAGONAL : Push the joystick diagonally, the camera move to that direction (direction 5 on figure 1)
103