Table of Contents
Advertisement
10. Pedestal Adjustment
11. Horizontal & Vertical Aperture Correction Slice Level Adjustment
12. Vertical Aperture Correction Slice Level Adjustment
13. Horizontal Aperture Correction (Low Band) Gain Level Adjustment
14. Horizontal Aperture Correction (High Band) Gain Level Adjustment
15. Vertical Aperture Correction Gain Control Adjustment
16. Horizontal & Vertical Aperture Correction Gain Adjustment
17. Manual Iris Speed Selection (Refer to Page33)
18. Manual Zoom Speed Selection (Refer to Page 29)
19. Manual Focus Speed Selection (Refer to Page 32)
20. Auto Focus Mode Selection (Refer to Page 31)
21. IR Cut Switch
Setup Menu Item Selection
1.
Click the Down button to select next item.
2.
Click the Up button to select previous item.
3.
Click the Left or Right button to make selection.
To Exit Setup Menu
Click ESC button, "Setup Initialize..." message will be displayed on the monitor for 4~5 seconds. All setting is stored in
the NDC.
5.2 Set Up Functions
Initial Setting (Factory Default)
To reset all functions back to initial factory setting:
1.
Click OSD(Enter) to recall OSD Setup Menu.
2.
Click the Up or Down button to select 1st item "Initial Set" on menu and click Left or Right button to make
selection. Once ON is selected, "Factory Initialize..." message will be displayed on screen for 4-5 seconds.
3.
When "Initialize" is done, monitor screen will switch back to Setup Menu.
4.
Click ESC button to exit menu, when finish or click Up or Down button to select next item.
61
Advertisement
Table of Contents
