Ash Removal; Raking Charcoal - Enerzone Destination 1.6 Installation And Operation Manual

Hide thumbs Also See for Destination 1.6:

Table of Contents

When you burn in cycles, you rarely need to open the wood fire's loading door while the wood is

flaming. This is an advantage because there is more chance that smoke will leak from the wood

fire when the door is opened as a full fire is burning. This is especially true if the flue connector has

90 degree elbows and if the flue system runs up the outside wall of the house.

IF YOU MUST OPEN THE DOOR WHILE THE FUEL IS FLAMING, OPEN THE AIR CONTROL FULLY FOR

A FEW MINUTES, THEN UNLATCH AND OPEN THE DOOR SLOWLY.

4.3.2 ASH REMOVAL

Ash should be removed from the firebox every two or three days of full time heating. Do not let

the ash build up in the firebox because it will interfere with proper fire management.

The best time to remove ash is after an overnight fire when the wood fire is relatively cool, but

there is still some flue system draft to draw the ash dust into the wood fire and prevent it from

coming into the room.

After ashes have been removed from the wood fire and placed in a tightly covered metal

container, they should be taken outside immediately. The closed container of ashes should be

placed on a non-combustible floor or on the ground well away from all combustible materials

pending final disposal. Ashes normally contain some live charcoal that can stay hot for several

days. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be

retained in the closed container until all cinders have thoroughly cooled. Other waste shall not be

placed in this container.

NEVER STORE ASHES INDOORS OR IN A NON-METALIC CONTAINER OR ON A WOODEN DECK.

Rekindle the fire when you notice that the room temperature has fallen. You will find most of the

remaining charcoal at the back of the firebox, furthest from the door. Rake these coals towards

the door before loading. There are two reasons for this raking of the coals. First, it concentrates

them near where most of the combustion air enters the firebox and where they can ignite the new

load quickly, and second, the charcoal will not be smothered by the new load of wood. If you were

to simply spread the charcoal out, the new load will smoulder for a long time before igniting.

Remove ash first, and then rake charcoal towards the front of the firebox before loading so that it

will ignite the new load.

Destination 1.6 Installation and Operation Manual

Table of Contents