Cleaning And Painting The Wood Fire - Enerzone Destination 1.6 Installation And Operation Manual

Apply self-adhesive gasket (C) en following the engraving on the inside of the door frame.
^
Reinstall the glass, being careful to centre the glass carefully in the door. Do not over-tighten the
screws. Note that the two main causes of broken door glass are uneven placement in the door and
over-tightening of retaining screws.
Do not abuse the glass door by striking or slamming shut. Do not use the wood fire if the glass is
broken. To change the glass, perform the same operation described above.

5.1.6 CLEANING AND PAINTING THE WOOD FIRE

Do not attempt to clean or paint the wood fire when the unit is hot. Painted surfaces can be
wiped down with a damp cloth. Plated surfaces may be scratched by abrasive cleaners. To
maintain the finish at its original brilliance, use only a damp soft cloth to clean plated surfaces.
If the paint becomes scratched or damaged, you can give your wood fire a brand new look by
repainting it with heat-resistant paint. Before painting, roughen the surface with fine sand paper,
wipe it down to remove dust, and apply two thin coats of paint. For best results, use the same
paint that was originally used on the wood fire, which is available in spray cans. See your dealer for
details.
27
Destination 1.6 Installation and Operation Manual