Communications Server - Nortel i2050 Installation Manual

Communications Server

If your site uses DHCP:
1
Select the Obtain server address automatically option.
Using DHCP is the default method of locating the Communications Server.
If DHCP is used, no further configuration is required.
Note: To use DHCP, you need a DHCP server with communications server IP
address values programmed as per the i2004.
If you are not using DHCP:
1
Select the Use the following server address information option.
2
Enter the name of the communications server and then enter or select the port number.
Or
Enter the IP address of the communications server and then enter or select the port number.
If you do not know the communications server name or IP address and port number, ask your
communications server administrator.
Note: Using DHCP may not be appropriate for mobile users. These users commonly
want to connect to their office communications server rather than the local office
server.
Chapter 2 Installing the i2050 Software Phone
i2050 Software Phone Installation Guide
21