Setting The Hunt Delay; Programming Busy Line Setting - Nortel ICS 6.1 Manual

176 / Programming Hunt Groups
5. Press
¨
6. Press

Setting the hunt delay

This setting allows you to program the number of rings the system permits
at a Hunt Group set before moving on to the next telephone in the Hunt
Group.
1. At
2. Enter the Hunt Group number you want to program (1-6) or press
3. Press
4. Press
5. Press
¨
6. Press

Programming busy line setting

A Hunt Group is considered busy if either of these two scenarios exist:
• all of its members are being presented an incoming Hunt Group call
• all of its members are active on a Hunt Group call
There are three routing options if all members are busy:
• BusyTone—the caller gets a busy tone
• Overflow—the call is routed to an overflow position
• Queue—the call stays in the system for a period of time. Within this
period of time, the call is presented to a member if one becomes
available. When the time-out occurs, the call is presented to an
overflow position.
1. At
2. Enter the Hunt Group number you want to program (1-6) or press
Compact ICS 6.1 System Coordinator Guide
to set the mode:
to exit or
, press
to scroll through the groups.
. The display shows
until the display shows
to select the setting:
to exit or
, press
to scroll through the groups.
,
to continue programming.
. The display shows
.
to continue programming.
. The display shows
, .
.
.
.
.
P0603544 02