Setting Up Telephone - Nortel Enterprise Edge M7208 Quick Reference Manual

Setting up the telephone
Connecting the cords
ATTENTION Before attempting to
carry out any work on the telephone,
ensure that the line cord is unplugged
from the wall socket.
To remove any of the cords, squeeze
the release latch on the plug and gently
pull the plug from the socket.
Connect the handset cord to the jack
labelled with the telephone icon and
route the cord as shown.
Connect to jack
If you are using a headset, route the
from distribution block
cord along the channel in the base and
connect the cord to the telephone jack
that is marked with the headset icon.
Connect to receiver
Route the line cord through the stand
and connect the cord to the telephone
jack that is marked with the jack icon.
Attach the stand using slots on the back
of the telephone.
Once the above work is complete, plug
the line cord back into its wall socket.
Page 5 Enterprise Edge M7208 Quick Reference Guide