Toshiba IPEDGE User Manual page 118

IPedge
IPMobility Application
Call-thru
Transfer
114
3. After a few seconds the mobile device will receive a call back from the host
IPedge system.
4. When the incoming call is answered, IPedge will automatically dial the
destination number.
5. Once the call is connected the same options are available as "Call Screening"
(press the IPMobility notification in the notification bar to access if not
displayed.)
To use the Call-thru feature:
1. Select the [Call] tab
Android handsets may use the default dialer Application and choose to
Note:
complete the action using IPMobility; Apple iOS phones do not support
this feature.
2. Enter a destination number on the call screen or select a number from your
address book and press dial.
The following call flow example assumes that "Ask Every Call" was set.
1. A popup screen is presented asking whether to use IPMobility or the phone
for out dial
2. Select IPMobility
3. IPMobility will dial the specified number to reach the IPedge and then the
destination number.
Once the call is connected you have the same menu options as described above.
Transfer the call to another extension of telephone number.
CDMA carrier-based plans (such as Verizon and Sprint) may not support
Note:
the Call Transfer feature
Android: While on a call, tap the status bar
iPhone: While on a call, switch to or open the IPMobility App and the screen will
display automatically.
TOSHIBA
IPedge UG 12/15