To Use A One Touch Button - Toshiba IPEDGE User Manual

IPedge
IPedge Enterprise Manager
Table 10: Special Characters
Entry Meaning
Indicates "stop." The One Touch button blinks rapidly and stops the delivery of the
*
Hold
+ remaining digits in the string until it is pressed again. Multiple "stops" can be
programmed into one string.
Pause (1~9) seconds. If you need to pause longer than nine seconds, enter additional
*
pause escape sequences. For example, to insert a 17-second pause, enter
(1~9)
display of a pause in the Speed Dial Number shows a "P" without specifying the
duration. In this example, you would see "PP."
** *
*
# #
Example of Special
Character Usage
To Use a One Touch
Button
126
• Station and System Speed Dial index numbers can be entered.
The Speed Dial index number will automatically dial out on the
extension or Line programmed on the One Touch button with the
associated Speed Dial index number.
Function buttons, except One Touch or a Program button.
•
• Handset hooking (on-hook/off-hook) cannot be recorded.
4. Enter the key strip label, eg., Engineering Conference, Cell, etc. This
label will display on your telephone.
5. Click OK, then the Save icon to save the entry.
To create a One Touch for Park and Page under one button, program the
following sequence under the One Touch button.
CNF #33***HOLD FB1 #30
CNF
– puts the caller on hold and gets new dial tone.
#33
– code to park call
**
– this special character outputs a single * which will select an available
orbit and display the selected orbit on the phone.
*
HOLD
– This special character is a Stop. The dial string pauses and
enables the user to view the selected orbit on the display. The dial string will
restart from this point when the One Touch button is pressed again.
FB1
– gets new dial tone on the PDN
#30
– code for All Call Page which allows the user to page the location of the
orbited call.
On your telephone, press the labeled One Touch button.
TOSHIBA
*9*8
. The
IPedge UG 12/15