Toshiba satellite A20 series Maintenance Manual page 412

4.30 Fluorescent Lamp
Assembling the 14.1-inch XGA Samsung Fluorescent Lamp
To assembling the 14.1-inch XGA Samsung fluorescent lamp, follow the steps below and
refer to figures 4-160 to 4-167.
1. Place the FL tube on the correct location in the frame.
2. Connect the ground wire to the frame.
3. Fix the back cover of the FL tube with the two screws.
4. Attach these:
• Reflective sheet
• Light guide plate (LGP)
• Diffuser sheet
• Prism sheet
5. Fasten the two clips.
6. Place the panel assembly on the correct location in the backlight assembly.
7. Place the upper chassis on the frame. Fit the hooks into the holes. There are four
hooks at the bottom, four hooks on each of the left- and right-hand sides, and six
hooks at the top.
8. Fix the power supply board with the two screws.
9. Attach the PCB cover and three pieces of tape.
Satellite A20 Maintenance Manual (960-444)
4 Replacement Procedures
4-207