4 Replacement Procedures
11. Stick the protection cover S (A), fixing tape (C), fixing tape for lead wire (D).
Fit the cover according to
the outline of the screw.
0 to 0.5 mm
Figure 4-136 Replacing Sharp fluorescent lamp (SXGA+) (24)
4-178
Stick to the side of the bezel.
Make sure the lead wire is
closely attached to the bezel.
(C)
(D)
The tape MUST NOT appear on the display.
Stick the tape according to the outline of the
module. Make sure the tape does not appear
on the side of the module.
0 to 1 mm
Do not make the tape over the
top of the module.
Satellite A20 Maintenance Manual (960-444)
4.30 Fluorescent Lamp
Fit the cover according to
the outline of the screw.
(A)
Stick the fixing tape at
the center of the module.