Toshiba satellite A20 series Maintenance Manual page 402

4.30 Fluorescent Lamp
4. Attach the protection cover S (A), protection cover G (B), aluminum tape (C), tape
for lead fixing (D), and aluminum shield (K). All of which must be new ones.
Attach the protection cover (A) then cover (B), using the engaging pins as the guide.
Fold the ends of the covers toward the side of the bezel.
• When attaching the aluminum tape (C)
− Align a longer side with the marking on the lamp cover on the reverse
− Align a shorter side with the edge of the lamp cover.
When attaching the tape for lead fixing (D)
− Align a shorter side with the location where the head of the screw is
When attaching the retention tape (H)
− Align both a longer and a shorter sides with the rectangular hole.
• When attaching the aluminum shield (K)
Figure 4-158 Attaching the protection cover and tapes
Satellite A20 Maintenance Manual (960-444)
side of the bezel.
Align a longer side with the marking on the lamp cover on the reverse
side of the bezel.
covered.
Align the corner of shield with the module corner.
4 Replacement Procedures
Engaging pins Rectangular hole
4-197