4.11 Memory Module
4.11 Memory Module
Removing a Memory Module
To remove a memory module, make sure the computer is in boot mode and powered off,
follow the steps below and refer to figures 4-18.
CAUTION: Do not try to remove a memory module with the computer turned on. The
computer or the memory might be damaged.
CAUTION: Do not touch the connectors on the memory module(s) or on the computer.
Debris on the connectors may cause memory access problems.
1. Turn up the insulator covering the memory slots.
2. Press out on two latches. One end of the memory module will pop up.
3. Grasp the memory module and pull it out to remove the memory module from PJ1400
(Slot A) or PJ1401 (Slot B) on the system board.
Insulator
Memory slot B
Memory slot A
Satellite A20 Maintenance Manual (960-444)
Figure 4-18 Removing the Memory module
4 Replacement Procedures
Two latches
Memory module
4-35