Sabo 54-K VARIO B Operator's Manual page 76

Cut not clean,
lawn turns yellow
Ejector blocked
The mulched grass does not look
good:
clumps, excessive cut material,
coarse cut
GB
In case of faults and defects which have not been listed here, please contact the nearest authorized dealer.
Repairs which require specialized knowledge should only be performed by a qualified expert. Your authorized dealer will
naturally also be glad to help if you do not wish to perform the maintenance work described here yourself.
Cutting blade blunt.
Cutting height too low.
Motor speed too low.
Mowing speed too high.
Insufficient overlap between mowing
lanes.
Lawn matted.
TurboSignal ignored J + K .
Motor speed too low.
Cutting height too low with grass too
high.
Mowing speed too fast.
Grass is damp.
Cutting blade blunt.
Mulching rule ignored (cut max. 1/3
of grass height; the grass height to
be cut must be less than 10 cm)
Driving speed too high.
Grass accumulation under the
mower blade.
Insufficient overlap between mowing
lanes.
Grass is damp.
20
Have it sharpened and balanced by an
authorised workshop Q .
Set higher cutting height I .
Work at max. speed.
Adapt mowing speed, switch motor drive off
if necessary.
If grass is long, the mowing lanes may need
to overlap further.
A perceptible improvement can be achieved
by using a scarifier.
Empty the collecting bag L .
Work at max. speed.
Set higher cutting height I .
Adapt mowing speed, switch motor drive off
if necessary.
Allow the lawn to dry.
Have it sharpened and balanced by an
authorised workshop.
Set higher cutting height I .
Convert mower to rear ejection U2 + S1 and
mow lawn with high cutting height first.
Adapt driving speed, switch motor drive off
if necessary.
Set higher cutting height I .
If grass is long, the mowing lanes may need
to overlap further.
Set higher cutting height I .
Allow the lawn to dry.