Reducing Noise In The Picture; Setting The Color Temperature; Adjusting The Color To The Desired Level - NEC PlasmaSync 50XM3 Model Information

Reducing noise in the picture

Use these settings if the picture has noise due to poor
reception or when playing video tapes on which the picture
quality is poor.
Example: Setting "NR-3"
1. On the MAIN MENU, select "PICTURE", then press
the MENU/ENTER button.
The "PICTURE" screen appears.
2. Use the and buttons to select "NR".
PICTURE
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
PICTURE MODE
NR
NEXT PAGE
SEL. ADJ.
3. Use the and buttons to select "NR-3".
The mode switches as follows each time the
button is pressed:
→ OFF ↔ NR-1 ↔ NR-2 ↔ NR-3 ←
NR
* If neither the or button is pressed within 5 seconds,
the current selection is set and the previous screen
reappears.
Information
NR
* "NR" stands for Noise Reduction.
* This function reduces noise in the picture.
Types of noise reduction
There are three types of noise reduction. Each has a
different level of noise reduction.
The effect becomes stronger as the number increases
(in the order NR-1 → NR-2 → NR-3).
OFF ............... Turns the noise reduction function off.
1 / 2
: NORMAL
: OFF
EXIT RETURN
or
: NR-3
E-20
3-89

Setting the color temperature

Use this procedure to set color tone produced by the plasma
display.
Example: Setting "HIGH"
1. On the MAIN MENU, select "PICTURE", then press
the MENU/ENTER button.
The "PICTURE" screen appears.
2. Use the and buttons to select "COLOR TEMP.".
3. Use the and buttons to select "HIGH".
The mode switches as follows each time the
button is pressed:
→ LOW ↔ MID LOW ↔ MID ↔ HIGH ←
* See below to set "WHITE BALANCE".
PICTURE
PREVIOUS PAGE
COLOR TEMP.
GAMMA
LOW TONE
COLOR TUNE
SEL. ADJ.
* If neither the or button is pressed within 5 seconds,
the current selection is set and the previous screen reappears.
Information
Setting the color temperature
LOW ................ Redder
MID LOW ......... Slightly redder
MID ................... Standard (slightly bluer)
HIGH ............... Bluer
Restoring the factory default settings
Select "ALL RESET" under the OPTION1 menu. Note
that this also restores other settings to the factory defaults.

Adjusting the color to the desired level

Use this procedure to adjust the white balance for each
color temperature to achieve the desired color quality.
Example: Adjusting the "GAIN RED" of "HIGH" color
temperature
Set "ADVANCED OSM" to "ON" in the main menu (1/
2), then perform the following operations.
Perform Steps 1-3 of COLOR TEMP., then...
4. Press the MENU/ENTER button.
The "WHITE BALANCE" screen appears.
5. Use the and buttons to select "GAIN RED".
WHITE BALANCE
COLOR TEMP. HIGH
GAIN RED
GAIN GREEN
GAIN BLUE
BIAS RED
BIAS GREEN
BIAS BLUE
RESET
SEL. ADJ.
CONFIDENTIAL
or
2 / 2
: HIGH
: 2
: AUTO
EXIT RETURN
: OFF
EXIT
RETURN