Motorcycle Division; Special Checks For The Correct Connection And Laying Of Cables - MOTO GUZZI NORGE GT 8V Service Station Manual

Norge GT 8v
•
No. 1 Ix 6.4x12x0.5 Ond Flexible Washer
•
No. 1 EBFM IX M8X1.25 nut
•
No. 1 Anti-vibration washer
•
No. 2 Adhesive cable grommet
•
No. 6 Cable grommets
•
No. 1 M6x16 screw
•
No. 2 TE FL M6x16 screws
•
No. 1 Cables retainer plate
•
No. 1 TCEI M6x18 screw
•
No. 2 SWP T. cross FL M5x20 screws
•
No. 1 Self-tapping screw for plastic 2.9x12

Motorcycle division

The wiring distribution is subdivided in three es-
sential sections, as indicated in the figure.
1. Front section
2. Central section
3. Rear section

Special checks for the correct connection and laying of cables

Below is the list of connectors for which the operator in charge of assemble must verify the correct
connection and tightening of any Secondary Lock, and "uncheck" the connector with a mark of indelible
ink:
•
Instrument Panel Connector.
•
Immobilizer connector
•
Pick-up connector
•
Side Stand Switch Connector
•
Right Cylinder and Left Cylinder Coil Connectors
•
Right and Left Injector Connectors
•
Stepper Connector and Throttle Sensor
•
Starter Command Connector (on the starter engine)
•
Starter Relays Connectors, Maintenance,1 Injection, 2 Injection
•
Fall sensor connector
•
Thermal Switch Connector, Electric Fan
•
Main Cable Harness Connector
•
Electric Fan Cable Harness
•
Engine Control Unit and Control Unit Casing Ground Connectors
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Electrical system
ELE SYS - 75