Troubleshooting - MOTO GUZZI NORGE GT 8V Service Station Manual

Norge GT 8v
Manually assemble the new sealing rings (2) and
(7).
Assemble the bushing (1).
Drive the bushing (1) in with a plastic hammer.
Turn the support (5) over and assemble the other
bushing (8).
Possible Cause
1. Fitting error of the radial seal or seal damaged 2. Sliding
surface of the wheel axle seal spoiled or damaged
1. Casing not sealed 2. Closing screws of the casing shells not
tightened to the prescribed torque
1. Dirt between the sealing ring and the casing 2. A used seal-
ing ring has been fitted 3. Plug not tightened to the prescribed
1. Cap damaged 2. Retaining clamp or closing cover loose 3.
Fitting error of the radial seal or seal damaged 4. Sliding sur-
face of the wheel spacer spoiled or damaged
1. Cap damaged 2. Internal retaining clamp or external closing
clamp loose
1. Bevel gear pair fitting error 2. Bevel gear pair toothing spoiled
or damaged
1. Ball bearings on the wheel axle damaged
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten

TROUBLESHOOTING

torque
Operation
1. Replace the sealing ring and fit it correctly with the suitable
tool
2. Replace the wheel axle
1. Open the casing shells, clean the surfaces, seal and reas-
semble the casing shells
2. Tighten the closing screws to the correct torque
1. Clean and tighten to the correct torque
2. Replace the sealing ring
3. Tighten the plug to the correct torque
1. Replace the cap
2. Screw the clamp with suitable pliers
3. Replace the sealing ring and fit it correctly with the suitable
tool
4. Replace the spacer
1. Replace the cap
2. Screw the internal or external clamp with suitable pliers
1. Replace the bevel gear pair
1. Replace the wheel bearings
Chassis
CHAS - 297