Table of Contents
Advertisement
WARNING:
4
Unscrew one of the two large screws, either at the side or rear of the camera body, depending
on where the video and power cables are to enter the camera body. Note that the screw is
wrapped in PTFE tape. This is necessary to ensure that moisture does not enter the camera
body after the camera has been installed.
5
Mark and drill the four screw holes required for fixing the camera body. An 8mm drill bit is
suitable for use with the supplied wall plugs.
Note:
If the video and power cables enter from the side of the camera, you may wish to fit a conduit
in position temporarily at the side of the camera to align the camera before marking the screw
holes.
If the video and power cables enter from the rear of the camera, mark and drill a hole for the conduit and
leads. The size of hole required depends on the size of the conduit.
6
Attach a metal or plastic conduit with a suitable M20 screw thread to the side or rear entry point
using PTFE tape to ensure a watertight seal. Ensure that the conduit does not foul the plastic
camera mount inside the camera body.
7
Screw the camera body to the fixing surface using the screws, wall plugs and o-rings supplied.
O-rings must be used to ensure that moisture does not enter the camera body after the camera
has been installed. Do not over-tighten the screws.
8
Take Anti-Static precautions
Dedicated Micros ©2011
Advertisement
Table of Contents
