Table of Contents
Advertisement
Warning:
Note:
To avoid unwanted reflections all LEDs within the camera including those on the network
connector are disabled. The LEDs are enabled if SW1.1 (which is situated close to the alarms
connector of the main board) is turned ON.
Power over Ethernet
The camera can be powered from any suitable PoE injector conforming to IEEE 802.3-2008. End span and
bridging injectors supported.
POE Injector
The Dedicated Micros POE Injector is designed to enable the use of POE (Power over Ethernet) before a
POE capable switch has been installed. It is installed alongside a suitable 48Vdc 15W PSU. (DM/PSU/48V
can be purchased separately from Dedicated Micros).
A
Connection to DVR/NVR/Switch
B
Connection to suitable 48Vdc 15W PSU (DM/PSU/48V recommended)
C
Ethernet cable connection to camera.
12
This camera is a Class 2 device and therefore does not have an earth connection in
the power cord.
Dedicated Micros ©2011
Advertisement
Table of Contents
