Table of Contents
Advertisement
Format (Red)
Stop Rec (Yellow)
Clear Video (Blue)
Refresh (Purple)
To format additional Video Storage
1.
Plug a USB storage device into one of the available USB ports and click the purple Refresh
button. The newly connected device will be displayed with a '/UDD' prefix. The SD card (if
installed) will also be displayed and can be allocated in the same way. USB devices will be
prefixed '/UDD', SD cards will be prefixed '/MDD'.
2.
The device may require formatting. DM recommends the device is formatted even if it was
previously been used as video storage. Click on the 'Format' button adjacent to the device
listing to prepare the device for recording.
3.
Allocate the formatted and mounted storage for video storage by clicking on the 'Allocate'
button. Allocation takes between a few seconds and a few minutes, depending on the size of
the drive, and the Feedback column will display information about the allocation process. The
unit will require a Reset once allocation is complete.
Note:
The unit application drive is protected, if it is allocated the unit will only remove the video folder.
Formatting any other device will remove all data. In either case recording on the system is
halted while formatting and, if already allocated, the formatted device will be de-allocated as a
video storage device
Prepares the media for video storage, refer to 'To format additional
Video Storage'.
Suspends Recording on the unit
Wipes the video from the drive to disable playback.
Refreshes the current page
Advertisement
Table of Contents
