Removing A Remote Supervisor Adapter Ii Slimline - IBM System x3650 Type 7979 Problem Determination And Service Manual

Hide thumbs Also See for System x3650 Type 7979:
Table of Contents

Advertisement

2. If you removed the PCI riser-card assembly to install the adapter, install the PCI
3. Connect any required cables to the adapter.
4. Perform any configuration tasks that are required for the adapter.
5. Install the cover (see "Installing the cover" on page 91).
6. Slide the server into the rack.
7. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing a Remote Supervisor Adapter II SlimLine

Note: Before removing a Remote Supervisor Adapter II SlimLine, create a backup
copy of the configuration so that if you are replacing the adapter, you can restore
the configuration.
To remove the Remote Supervisor Adapter II SlimLine, complete the following
steps.
Retainer bracket
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the server cover (see "Removing the cover" on page 90).
4. Remove the PCI riser-card assembly (see "Removing the riser-card assembly"
5. Spread the tabs of the latch bracket apart and lift the end of the Remote
6. Lift the Remote Supervisor Adapter II SlimLine out of the server.
7. If you are instructed to return the Remote Supervisor Adapter II SlimLine, follow
riser card assembly (see "Installing the riser-card assembly" on page 98).
Attention:
v When you route cables, do not block any connectors or the ventilated space
around any of the fans.
v Make sure that cables are not routed on top of components under the PCI
riser-card assembly.
v Make sure that cables are not pinched by the server components.
peripheral devices and the server.
Remote Supervisor
Adapter II SlimLine
on page 87.
all external cables.
on page 96).
Supervisor Adapter II SlimLine, until the tabs release the adapter; then, slide the
other end of the Remote Supervisor Adapter II SlimLine out of the retainer
bracket.
all packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Latch bracket tabs
Chapter 4. Removing and replacing server components
101

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3650 type 1914

Table of Contents