Table of Contents
Advertisement
13
SETTING MODE
g
Important!!
The subjects described in this
chapter apply to each boiler module.
13.1 User level setting mode (X [[)
Setting mode is used to change various settings to suit
individual requirements. The required code is selected
by pressing the m key until ! appears in the code win-
dow. Select the required code with the s key. Now
press the [+] key to increase a setting or the [-] key to
decrease a setting.
Press the e key to store the new setting. The new
value will flash twice in the t window to confirm the
setting.
Code Description
Setting range
and explana-
tion if neces-
sary
Flow tempera-
20 to 90°
!
ture setpoint,
(boiler thermo-
see section
stat setting,
13.1.1
also top heating
curve setting if
external sensor
is used)
fig. 25
Setting flow temperature
pdf
Pump run on
@
setting, see
section 13.1.2
Boiler control
A
setting (per
module), see
section 13.1.3
Factory
setting
table 17 Settings mode user level
g
Important!!
be on design engineers advice.
90
13.1.1 Flow temperature (!)
The required flow temperature is adjustable from 20 to
90°.
The following diagram shows a typical example of this
procedure:
38
Remeha Gas 610 ECO
00 =
pump run on 10
seconds
01 - 15 =
pump run on in
minutes
99 =
continuous
pump operation
Control mode
(modulating-on/
off-etc.)
Changing @ and A should only
05
51
Hide quick links:
Advertisement
Table of Contents
