General Operation; Important; Information Banner - Telefunken T42A857FHD Instruction Manual

The IDTV will automatically tune to the UHF or
VHF (** for EU countries) transmission channels,
searching for digital terrestrial TV broadcasts
and displaying the names of channels found.
This process will take about a few minutes. To
cancel searching, you can press the "MENU"
button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
Either you select AERIAL or CABLE option
from the search type menu, after the digital
automatic search is completed, the following
message asking for analogue channel search
appears on the screen:
To search for analogue channels, select "Yes".
TV switches to the analogue TV mode. The
menu below is displayed to search for analogue
channels:
Select your Country, Language and Text
language by using " " or " " and " " or " "
buttons. Press OK or RED button to continue.
To cancel, press the BLUE button.
For more information on this process, see
"Install Menu" section.
02_[GB]_SSM_MB35_42857W_1900UK_IDTV_TC_PVR_100HZ_SILVER1_10065463_50156645.indd 90 02_[GB]_SSM_MB35_42857W_1900UK_IDTV_TC_PVR_100HZ_SILVER1_10065463_50156645.indd 90
Note : For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK broadcasts only).
Do not turn off the TV while initializing fi rst time
installation.

General Operation

Press the SOURCE button on the remote control
and select DTV/USB to switch the TV set to
digital terrestrial television broadcasting.

Important!

Whenever you connect an external USB disk
and switch on the TV, duration of the hard disk
initialization process may take approximately
1-5 minutes, depending on its fi le capacity and
space.

Information Banner

• Whenever you change channel, using the
P- / P+ button or the numeric buttons, the TV
displays the broadcast picture along with an
information banner at the bottom of the screen
(available only in DTV mode). This will remain
on the screen for a few seconds.
• The information banner can also be displayed
at any time while watching TV by pressing the
INFO button on the remote control:
The information banner gives information on the
channel selected and the programmes on it. The
name of the channel is displayed, along with its
channel list number. Broadcast type information
is also displayed.
Hint: Not all channels broadcast the programme
data. If the name and time of the programme are not
available, then information banner will be displayed
with blanks.
• Icons are also displayed in the information
banner and if this channel is a favourite
channel, favourite channel icon will also be
displayed.
English - 90 -
05.10.2009 20:12:54 05.10.2009 20:12:54