Telefunken T42A857FHD Instruction Manual page 110

The IDTV will automatically tune to the UHF or
VHF (** for EU countries) transmission channels,
searching for digital terrestrial TV broadcasts
and displaying the names of channels found.
This process will take about a few minutes. To
cancel searching, you can press the "MENU"
button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
Either you select AERIAL or CABLE option
from the search type menu, after the digital
automatic search is completed, the following
message asking for analogue channel search
appears on the screen:
To search for analogue channels, select "Yes".
TV switches to the analogue TV mode. The
menu below is displayed to search for analogue
channels:
Select your Country, Language and Text
language by using " " or " " and " " or " "
02_[GB]_SSM_MB35_42857W_1900UK_IDTV_TC_PVR_100HZ_SILVER1_10065463_50156645.indd 108 02_[GB]_SSM_MB35_42857W_1900UK_IDTV_TC_PVR_100HZ_SILVER1_10065463_50156645.indd 108
buttons. Press OK or RED button to continue.
To cancel, press the BLUE button.
For more information on this process, see
"Install Menu" section. +
Note : For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK only).
Media Browser
• To display Media Browser window, press
either " M " button on the remote control and
then select Media Browser by pressing " "
or " " button. Press OK button to continue.
Media Browser menu contents (depending
on the contents of your USB drive) will be
displayed.
• Also, when you plug a USB device, the
following screen will be displayed:
Select YES by pressing " " or " " button
and press OK button. Media browser will be
displayed.
• You can play supported music, picture or video
fi les from a USB memory stick.
Note : If you plug USB stick while in analogue mode,
the TV will automatically switch to digital TV mode.
Note : Some USB compliant devices may not be
supported.
Note : If the USB stick is not recognized after power
off/on or First Time Installation, fi rst, plug the USB
device out and power off/on the TV set. Plug the USB
device in again.
English - 108 -
05.10.2009 20:13:01 05.10.2009 20:13:01