Telefunken T42A857FHD Instruction Manual page 109

Press OK to cancel. Select Yes by pressing "
" or " " button and press OK to delete all of
the channels.
First Time Installation
The user can use this item to load default
settings, which were loaded to the receiver at
the factory.
To install factory settings, highlight "First Time
Installation" menu item and press OK button,
then you will be asked whether or not to delete
the settings. Selecting "Yes" by pressing OK
button while the "Yes" is highlighted will delete
the existing channel table.
Then you will be asked to confi rm for deleting
all channels and settings:
By selecting Yes and pressing the OK button,
the existing channel table will be deleted.
After factory settings are loaded, "First Time
Installation" menu will be displayed.
The menu which is displayed for language
selection appears on the screen at fi rst.
By pressing the " " or " " buttons highlight the
language you want to set and press OK button.
After then, "First time installation" OSD will
appear on the screen. By pressing " " or " "
buttons, select the country you want to set and
press OK button (** for EU countries).
Note: Country selection OSD will not be available
for UK.
After "First time installation" is performed, the
following message appears on the screen:
To start installation process, select "Yes", to
cancel select "No".
02_[GB]_SSM_MB35_42857W_1900UK_IDTV_TC_PVR_100HZ_SILVER1_10065463_50156645.indd 107 02_[GB]_SSM_MB35_42857W_1900UK_IDTV_TC_PVR_100HZ_SILVER1_10065463_50156645.indd 107
• To select the "Yes" or "No" option, highlight the
item by using " " or " " buttons and press the
OK button.
After then, the following OSD will be displayed
on the screen:
If you select CABLE option, the following screen
will be displayed:
You can select frequency ranges from this
screen. For highlighting lines you see, use "
" or " " button. You can enter the frequency
range manually by using the numeric buttons
on the remote control.
• After this operation, you can set Search Step
as 8000 KHz or 1000 KHz. If you select 1000
KHz, the Tv will perform search process in
a detailed way. Searching duration will thus
increase accordingly. When fi nished, press
OK button to start automatic search. Automatic
searching screen will be displayed during the
process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
If you select AERIAL option from the Search
Type screen, the digital television will search
for digital terrestrial TV broadcasts:
English - 107 -
05.10.2009 20:13:01 05.10.2009 20:13:01