Advanced Settings - Tone Generator - Grandstream Networks GAC2500 Administration Manual

Conference Server
Enable Conference
Room Quite Mode
Record Mode
Auto Mute on Entry
Ignore early media in
conference
Advanced Settings – Tone Generator
Table 30: Advanced – Tone Generator Settings
Auto Config CPT by Region
Call Progress Tones:
● Dial Tone
● Ring Back Tone
● Busy Tone
● Reorder Tone
● Confirmation Tone
● Call-Waiting Tone
● PSTN Disconnect Tone
Call-Waiting Tone Gain
Ring Cadence
"Rich voices" focuses on low and medium
frequency and sounds deep to human ears.
"Clear voices" focuses on medium and high frequency and it sounds bright to
human ears.
The degree of "Small room & Denoise" is 18db.
The degree of "Small room & Enhance Denoise" is 24db.
The default setting is "Large room & Clear".
Enables this function to access conference mode, all lines will be in conference
room and single line operation is prohibited. The default setting is "No".
Configures whether to enable voice prompt when conference members enter or
exit the conference. Once enabled, when a member enters or exits the conference,
members online can hear the corresponding voice prompt. The default is "No"
Selects recording mode location; locally or on server.
Configures whether to mute the call on entry automatically.
"Disable" means that the feature is not used.
"Auto Mute on Outgoing Call" will mute automatically when the other party
answers the outgoing call.
"Auto Mute on Incoming Call" will mute automatically when answers the
incoming call.
"Mute on Incoming & Outgoing Call" will mute automatically when the call
gets through.
Users could click the Mute button on call interface to cancel the current mute
status. The default setting is "Disable".
Once enabled, the device would not play early media in an outgoing call in
conference.
P-value is 22222. Default is No – 0.
If set to "Yes", GAC2500 will configure CPT (Call Progress Tone) according to
different regions automatically. If set to "No", you can configure CPT parameters
manually. The default setting is "No".
Configures tone frequencies according to user preference. By default, the tones are
set to North American frequencies. Frequencies should be configured with known
values to avoid uncomfortable high pitch sounds. Syntax: f1=val,f2=val
[,c=on1/off1[-on2/off2[-on3/off3]]]; (Frequencies are in Hz and cadence on and
off are in 10ms) ON is the period of ringing ("On time" in "ms") while OFF is the
period of silence. In order to set a continuous ring, OFF should be zero.
Otherwise it will ring ON ms and a pause of OFF ms and then repeats the pattern.
Please refer to the document below to determine your local call progress
tones: http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
By default, tones are set to the North American standard. Users could adjust the
tone frequencies based on parameters from the local telecom provider. Users could
select "Low", "Medium" or "High". The default setting is "Low".
Defines the ring cadence for the phone. The default setting is: c=2000/4000