Toshiba MD-VNK802HEXE Service Manual page 126

◆ Display section
All indicators are displayed on the display example below for explanation. In
reality, only the selected options will be displayed. Indications concerning
controlling the Air to Air Heat Exchanger with DX Coil Unit are explained here.
For indications concerning an air conditioner, refer to the owner's manuals
supplied with the remote controller and the air conditioner.
• blinks on the display of the remote controller when the power switch
is turned on for the first time.
The initial settings progress while
controller after
NOTE
The LCD may temporarily be blurred due to static electricity.
1
SETTING indicator
Displayed when setting the timer or other
functions.
2
Operation mode indicator
Indicates the operation mode selected.
3
Error indicator
Displayed when the protective device activates or
an error occurs.
4
Time indicator
Indicates time concerning the timer.
(Indicates a error code when an error occurs.)
5
Timer mode indicator
Each time you press the
indication changes as follows:
, , and no timer indication.
6
Filter indicator
Reminder to clean the air filter.
7
Test run indicator
Displayed during a test run.
8
Louver position display (*1)
9
Swing indicator (*1)
is blinking. Start to use the remote
has disappeared.
button, the
,
10
Set temperature display
The selected set temperature is displayed.
11
Remote controller sensor indicator
Displayed when the remote controller sensor is
used.
12
Pre-heat indicator
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this indication is displayed, the indoor fan
stops or operate in fan mode.
13
No function indicator
Displayed when the function requested is not
available on that model.
14
Fan speed indicator (*1)
Indicates the selected fan speed:
(Auto)
(High)
(Medium)
(Low)
124
Owner's Manual
Display
section
Operation
section