Wheels And Tires; Tire Repair; Fig. 10 Lifting The Vehicle - Ezgo 605681 Owner's Manual And Service Manual

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack at the center of the front axle. Raise the
vehicle enough to place jack stands under the frame
crossmember as indicated.
Lower the jack and test the stability of the vehicle on all
four jack stands.
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
Center of
Front Axle
View from Underside of Vehicle
Ref Liv 1

Fig. 10 Lifting the Vehicle

WHEELS AND TIRES

Tire Repair

Tool List
Lug wrench, 3/4" ......................................................... 1
Impact socket, 3/4", 1/2" drive..................................... 1
Impact wrench, 1/2" drive............................................ 1
Torque wrench, 1/2" drive ........................................... 1
A tire explosion can cause severe injury or
death. Never exceed inflation pressure rating
on tire sidewall.
O P E R A T I O N A N D S E R V I C E I N F O R M A T I O N
Flat Portion
of Frame
Outside End
of Rear Axle
Qty. Required
Owner's Manual and Service Guide
To reduce the possibility of tire explosion,
pressurize tire with small amount of air
applied intermittently to seat beads. Due to
the low volume of the small tires, overinfla-
tion can occur in seconds. Never exceed
the tire manufacturer's recommendation
when seating a bead. Protect face and eyes
from escaping air when removing valve
core.
To reduce the possibility of severe injury
caused by a broken socket when removing
wheels, use only sockets designed for
impact wrench use.
Use caution when inflating tires. Overinfla-
tion could cause the tire to separate from
the wheel or cause the tire to explode,
either of which could cause severe injury.
Use caution when inflating tires. Due to the low volume of
the small tires, overinflation can occur in seconds. Over-
inflation could cause the tire to separate from the wheel
or cause the tire to explode.
Tire inflation should be determined by the condition of
the terrain. See GENERAL SPECIFICATIONS section
for recommended tire inflation pressure. For outdoor
applications with major use on grassy areas, the follow-
ing should be considered. On hard turf, it is desirable to
have a slightly higher inflation pressure. On very soft
turf, a lower pressure reduces the possibility of tires cut-
ting into the turf. For vehicles being used on paved or
hard surfaces, tire inflation pressure should be in the
higher allowable range, but under no condition should
inflation pressure be higher than recommended on tire
sidewall. All four tires should have the same pressure
for optimum handling characteristics. Be sure to install
the valve dust cap after checking or inflating.
The vehicle is fitted with low pressure tubeless tires
mounted on one piece rims; therefore, the most cost
effective way to repair a puncture in the tread is to use a
commercial tire plug.
Tire plug tools and plugs are available at most automotive parts
outlets and have the advantage of not requiring the tire be
removed from the wheel.
Page 9