Wheels And Tires; Tire Repair; Fig. 10 Lifting The Vehicle - Ezgo 2010 TXT 48 FLEET Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of manual to become familiar with this vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.
B
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
Center of
Front Axle
View from Underside of Vehicle

Fig. 10 Lifting the Vehicle

WHEELS AND TIRES

TIRE REPAIR

Tool List
Lug Wrench, 3/4" ......................................................... 1
Impact Socket, 3/4"...................................................... 1
Impact Wrench ............................................................ 1
Torque Wrench, ft. lbs.................................................. 1
A tire explosion can cause severe injury or
death. Never exceed the inflation pressure rat-
ing on the tire sidewall.
To reduce the possibility of tire explosion,
pressurize tire with small amount of air applied
intermittently to seat beads. Due to the low vol-
ume of the small tires, overinflation can occur
in seconds. Never exceed the tire manufactur-
er's recommendation when seating a bead.
Protect face and eyes from escaping air when
Page 10
removing a valve core.
To reduce the possibility of severe injury
caused by a broken socket when removing
wheels, use only sockets designed for impact
wrench use.
Use caution when inflating tires. Overinflation
could cause the tire to separate from the wheel
or cause the tire to explode, either of which
could cause severe injury.
DO NOT use low inflation tires on any E-Z-GO
vehicle. DO NOT use any tire which has a rec-
ommended inflation pressure less than the
inflation pressure recommended in the owner's
guide.
Use caution when inflating tires. Due to the low volume
of the small tires, overinflation can occur in seconds.
Flat Portion
Overinflation could cause the tire to separate from the
of Frame
wheel or cause the tire to explode.
Tire inflation should be determined by the condition of
the terrain. See GENERAL SPECIFICATIONS section
for recommended tire inflation pressure. For outdoor ap-
plications with major use on grassy areas, the following
should be considered. On hard turf, it is desirable to
Outside End
have a slightly higher inflation pressure. On very soft
of Rear Axle
turf, a lower pressure reduces the possibility of tires cut-
ting into the turf. For vehicles being used on paved or
hard surfaces, tire inflation pressure should be in the
higher allowable range, but under no condition should
inflation pressure be higher than recommended on tire
sidewall. All four tires should have the same pressure
for optimum handling characteristics. Be sure to install
the valve stem dust cap after checking or inflating.
Qty.
The vehicle is fitted with low pressure tubeless tires
mounted on one piece rims; therefore, the most cost ef-
fective way to repair a puncture in the tread is to use a
commercial tire plug.
Tire plug tools and plugs are available at most automotive
parts outlets and have the advantage of not requiring the tire
be removed from the wheel.
If the tire is flat, remove the wheel and inflate the tire to
the maximum recommended pressure for the tire. Im-
merse the tire in water to locate the leak and mark with
chalk. Insert tire plug in accordance with manufacturer's
instructions.
Owner's Guide
NOTICE