Hyundai UM 500 Instruction Manual page 43

Turning regulator (A1)
0 position: the appliance is off.
1, 2 position: the appliance is on. It enables setting the optimum revolutions for the selected
work adapter. It is intended for blending, whipping, grating, preparing a mash,
squeezing juices and very fine chopping.
P (PULSE): the motor runs only when the regulator is setting (maximum performance).
It is intended for cutting, blending and for normal to rough chopping. Push
several times until you get the required result.
Safety lock (A2)
• It prevents starting the appliance if bowl B, blending bowl E is not properly mounted on drive
unit A, lid D and press G on bowl B.
• It switches off the appliance if the bowl, lid, press and pusher become unsecured.
Home blender (Fig. 2, 3, 4, 5, 6, 7, 8)
Mounting and removal of drive shaft (C)
Driver shaft C on motor base A3. You can remove the drive shaft in the opposite direction.
Mounting and removal of bowl (B)
Mount the bowl on drive A7 so that it slides down, then secure it by turning it clockwise till
you hear a snapping sound (at the same time, the safety lock is unlocked). Pay special
attention to this operation. You can remove the bowl in the opposite direction.
Mounting and removal of bowl drive shaft (B1)
Bowl drive shaft B1 on driver shaft C. You can remove the bowl drive shaft in the opposite
direction.
Mounting and removal of lid (D), (Fig. 2, 3, 4, 6)
Remove and mount the lid only when turning regulator A1 is in the 0 position.
Put the lid on bowl B so that the moulded hole on its edge fits exactly to the protruding
part on the edge of the bowl. Turn the lid clockwise till securing lug D1 snaps in the cut in the
bowl handle (at the same time, the safety lock is unlocked). Pay special attention to this
operation. The lid is now secured in the proper position and drive unit A can work. You can
remove the lid in the opposite direction.
Filling hole (D2), pusher (F), (Fig. 2, 3, 4, 6)
You can add liquids or solid ingredients through the filling hole when drive unit A is on.
Use pusher F to move food in the filling hole.
Note:
• The maximum level for filling the hole is ¾ of its volume.
Using accessories
Sickle-shapes knives (H), (Fig. 2)
Assembly
Hold the knife at the plastic part and put its central hole to shaft B1, let it slide on the
shaft to the maximum position. Turn the knife to the right position. Remove the knife in the
opposite direction. Put the knife to the bowl always before adding ingredients.
ATTENTION
• The small bowl in intended for use with small sickle-shaped knife I only; do not use it in
combination with graters.
43 / 62
ENG