Problems - Troubleshooting - Jøtul I 80 Mini Classic Installation And Operating Instructions Manual

ENGLISH
Unscrew the screws (A) in the lower front edge of the
2.
combustion chamber half way out and pull the washers all
the way out towards the screw head.
Loosen the screws (B) in the upper front edge of the
3.
combustion chamber. These screws have washers and nuts on
the inside. When the last screw is loosened, you must support
the front so that it does not fall forward.
4. Lift the front off.
5. Assembly is achieved by placing the front on the two half-
screwed-in screws (A) in point 2. The front has tracks where
the screws should fit into place.
6. Push the frame into the upper edge - lift it up so that it
reaches the top. Fasten the frame with screws (B) M6x30mm
and washers with nuts on the inside of the combustion
chamber.
26
8.0 Reasons for operational

problems - troubleshooting

Poor draught
• Check the length of the chimney and that it complies with
national laws and regulations. Make sure that the minimum
cross section on the chimney is large enough. See also «2.0
Technical data» and «4.5 Chimney» for information.
• Make sure that there is not anything preventing the smoke
gasses from escaping: Branches, trees, etc.
The fire extinguishes after a while
• Make sure that the firewood is sufficiently dry
• Find out whether there is negative pressure in the house, close
mechanical fans and open a window close to the stove.
• Check that the air vent is open.
• Check that the flue outlet is not clogged by soot
Unusual amount of soot accumulates on the
glass
Some soot will always stick to the glass, but the quantity depends on:
• Humidity of the fuel.
• The local draught conditions
• Regulating the air vent.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.«6.1
Cleaning the glass - good advice» .