Service - Jøtul I 80 Mini Classic Installation And Operating Instructions Manual

6.6 Exterior maintenance
Painted products may change colour after several years usage.
The surface should be cleaned and brushed free of any loose
particles before new paint is applied.
Enamelled products must only be cleaned with a clean, dry cloth.
Do not use water and soap. Any stains can be removed with a
cleaning fluids (Oven cleaner etc.).

7.0 Service

Warning! Any unauthorised change to the product is illegal! Only
use original spare parts!
7.1 Changing the burn plates (fig. 9)
1. Lift up the ash moulding on the one side so that it comes
out of the harbours on the side of the combustion chamber
and then remove it.
2. Take the air distributor out (the little part with a hole in the
bottom of the combustion chamber).
3. Remove the side burn plates by lifting these up slightly with
the aid of the burn plates' cams (at the bottom) and pull out.
If they are stuck, a screwdriver may be used to flip them up.
4. Then lift the back burn plate out.
5. Before putting the burn plates in place, check that the
insulation is in place.
6. Start with the back burn plate first. Then the side burn plates
are shoved into place; lift them up slightly with the aid of
the cams at the bottom of the plates, so that they are locked
into place by the border in the hearth.
7.2 Changing the air chamber (fig. 10)
1. Remove the burn plates (see relevant section).
2. Pull the air chamber forward while at the same time lifting
it up at the edge. Edge it down and remove it through the
opening in the door. Be aware that the part is heavy!
3. Before replacing the air chamber, check that the gasket is in
place in the groove.
4. Take the air chamber in to the hearth and place it on the front
cams on the side pieces. Then lift it up a little at the front,
before the back edge is lifted and pushed in on the horizontal
rib close to the back wall.
7.3 Changing the baffle plate (fig. 10)
1. In order to remove this, the burn plates and the air chamber
(B) must be removed first. See relevant section.
2. Lift the baffle plate up into the back edge, then push it back
a little. After that, it is lifted down in the front edge and out
through the doors.
To put the baffle plate (A) into place, put the cams at the back
3.
edge of the plate on the side ribs behind the side pieces. Lift
up the back edge and push backwards.
4. Lift the baffle plate up at the front edge and pull it forward,
so that it rests on the foremost cams on the side pieces.
7.4 Dismantling/assembly of the door(s)
1. In order to remove the door(s), they must first be opened.
2. Loosen the grub screws and pull out the door(s).
3. When assembling the door(s), any washers under the
lowermost grub screws must be put in place.
4. Change the gasket at the same time.
7.5 Dismantling/assembly of the front
(fig. 12)
1. Dismantle the doors, ash lip, burn plates, air chamber, baffle
plate and the damper - if it has been installed. (See relevant
section).
ENGLISH
25