Can-Am DS 250 Operator's Manual page 77

vmo2011-001-002_a
TYPICAL — MULTIFUNCTION SWITCH
1. Headlights switch
2. Emergency engine stop switch
3. Engine start button
4. Override button
5. Choke lever
Headlights Switch
This is a 3 position switch that controls
the taillight and headlights simultane-
ously however, it has no effect on the
brake light.
vmo2011-001-005_a
TYPICAL — HEADLIGHTS SWITCH
FUNCTIONS
1. Headlights switch
2. Low beam and taillight
3. High beam and taillight
4. OFF position
Emergency Engine Stop Switch
This switch can be used to stop the en-
gine and as an emergency control.
CONTROLS/INSTRUMENTS/EQUIPMENT
NOTE: While the engine can be
stopped by turning the ignition key
to the OFF position, we recommend
the engine be stopped using the emer-
gency engine stop switch.
To stop the engine, fully release throt-
tle lever, then set the emergency en-
gine stop switch to the STOP position.
vmo2011-001-003_a
TYPICAL - EMERGENCY ENGINE STOP
SWITCH
1. RUN position
2. STOP position
Engine Start Button
To start engine, set the emergency en-
gine stop switch to RUN position.
Press and hold the engine start button,
release immediately after engine is
started.
_______________
75