Ignition Switch; Fuel Valve - Can-Am DS 90 Operator's Manual

Reverse Lamp (RED)
When lit,
transmission
position.

8) Ignition Switch

The ignition switch is located in the
middle of the handlebar.
It is a key-operated, 2 position switch:
OFF and ON.
vmo2008-008-012_a
IGNITION SWITCH
1. OFF position
2. ON position
Insert key in switch and turn to ON po-
sition. To remove key, turn key to OFF
position then pull it out.
NOTE: While the engine can be
stopped by turning ignition key to OFF
position, we recommend the engine
be stopped using the emergency en-
gine stop switch. Always turn ignition
switch to OFF position after engine
has been stopped.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
it indicates the
is in reverse
WARNING
_______________
CONTROLS/INSTRUMENTS/EQUIPMENT

9) Fuel Valve

The fuel valve is located on the LH side
of the vehicle near the engine.
This is a 3 position rotary valve: OFF,
ON, RES (reserve). Rotate the valve to
align its arrow to the desired position.
vmo2013-004-005_a
LH SIDE OF VEHICLE
1. Align this arrow toward the desired position
NOTICE
Improper opening of fuel
valve will restrict the flow of fuel.
Make sure valve is fully opened
when engine is running.
OFF
Stops fuel supply to carburetor.
NOTICE
Turn fuel valve to OFF
position as soon as the engine is
stopped.
ON
Allows fuel to flow to carburetor. This
is the normal position for operation of
the vehicle.
67