Mechanical Brakes (Ds 90); Brake System - Can-Am DS 90 Operator's Manual

Suspension Lubrication
Rear Suspension
Lubricate swing arm pivots.
synthetic SUSPENSION
(P/N 293 550 033) or an equivalent.
vmo2006-014-061_a
LH SIDE OF VEHICLE
1. CVT duct
2. Grease fitting
Mechanical Brakes
(DS 90)
Mechanical Brake Inspection
WARNING
Any brake system repair should
be performed by an authorized
Can-Am Dealer.
CAUTION The brakes can be
very hot after prolonged use of the
vehicle and can cause burns. Wait
for the brakes to cool down.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
Check brake lever free-play (both
levers), adjust if necessary.
Check for lever operation, they should
Use
move freely and have a firm feel when
GREASE
brakes are applied.
If correct adjustment is unattainable,
see an authorized Can-Am dealer for
cable replacement.
Inspect brake cables for excessive
wear, kinking or fraying.
Replace any cable that show signs of
wear, fraying or other damages.
Lubricate cables using CABLE LUBRI-
CANT (P/N 293 600 041) to reduce
premature wear and to ensure proper
movement of the cable.
Always use a silicone-based lu-
bricant. Using any other lubricant
(such as a water-based lubricant)
may cause the brake cables to stick
or become stiff.
Have your authorized Can-Am dealer
inspect brake shoes for wear or dam-
age.
BRAKE SHOE MINIMUM THICKNESS
See your authorized Can-Am dealer if
a problem is detected concerning the

brake system.

WARNING
______________
MAINTENANCE PROCEDURES
WARNING
FRONT AND
REAR
1.5 mm (.06 in)
101